www.max-carpfishing.it

Hello, this time I want to show you how I solved a small problem that I had whenever confronted a joke with the technique of Long-Range. I wanted a marker handy, ready, fast in laying, always visible and economically.
I was missing and I realized at a cost of 5 euros.
Required:
For the ballast:
A little 'lead by merging, and a band of metal packaging.
For the marker:
Panel insulation thickness 7 / 8 cm.
To make it visible at night:
A little lamp solar gardens (5 euros to briko).
A screw with eyelet, 1 die and washers.
Material reflecting:
I have recovered an old suit of civil protection but goes well little jacket by a car or similar, 10 m. of rope or more, depending on how deep is the place frequented. A metre of elastic from "pants grandmother"
Realization ballast:
Photo1.
Making metal band with a mould shaped H, and lean it on a steel plate.
Melt it lead and lar into the mould in this way we will have the ballast; to give you an idea of weight with a length of 11 cm and width of 8 cm and a thickness of 0.5 cm results in a weight from 450 grams, suitable for marker with a diameter 16 cm. and 8 cm thick.
The marker must be able to raise the lead so that if the rope being dropped is twist the marker will support the ballast and not disappear into the blue we will see our work ....
Realization marker:
Photo 2.
Cut the piece of insulating shaped cylinder with a diameter of 16 cm, after the centre "mollow out" a home for little lamp.
Photo 3.
The headquarters must be profound for not projecting reflections in water or worse direct light. Perforate the basis of little lamp and with the bolt the block.
Photo 4.
To improve visibility with a piece of reflective tape we make a band around the cylinder and the set.
Photo 5.
We just have to tie one end of the rope at the centres of ballast of lead, and the other head with the flexible top of the marker.
Photo 6.
Roll up the rope at the centres of the sinker and you're done.
Found the place where magic set our bait in the water we support the marker.
Do not forget to turn on the switch of first little lamp!
We will see un roll quickly the rope until the ballast arrives on the bottom, in our marker is placed.
When darkness in the evening will be welcomed by this "nice light."
I hope for all by sounds and flash photographs ...
The position for our bait will be easily accessible, thanks to light that emanates the marker.
In the case of long winter sessions, charging from solar panel is not sufficient for the whole night, but there is help the reflective band, visible even with a small LED light front.
Photo 7.
I made a cheap variant, using a plastic bottle for water, half litre. The use where some passing boat, by mistake, "damn" our token .... already happened!
I put the usual reflective tape around the bottle. I used a piece of suit (which is a beautiful orange) sewn to the black cloth that see well with time foggy typical winter.
At the end of the session we will be "REQUIRED" to collect our marker (visa cost but above all the work), not as some people who attend our waters, leaving traces of their intelligence in the place where they caught.
By the way, I could suggest a 'idea that use in fishing in rivers where the debris carried by the current may sink our attention. With one euro buy a ball of twine that after a few days immersion breaks freeing the bottle and the location from a dangerous footing for the line. Instead of lead enough shape a brick-shaped H with a grinding wheel angle and disc suitable.
After various tests I did not find any defects.
Very useful to those who, like me, does not see well.
Secure the laying because they rule alone that we should not tie anything, to set the depth, having to protrude from the boat from the boat.
Photos 8 / 9
Stable to the wind and in the event of changes in water level ranks alone to the fullest.
Reliable electricity in part because it is built for outdoor then ..... good job !!!!!!!

Hello Bepi Change

NB = Decathlon At a jacket rescue size XXL 15 euros and saves us the life !!!!!